pbillyi69's latest activity
-
A small collection that I'm going to go over, inspect, clean, shine up, then we'll see if any remain or if they get dumped on the... -
pbillyi69 replied to the thread What's on your bench?.so yesterday morning before i took it back, i wanted to start it and its a no go and flooded a rediculous amount of gas. so took the...
-
Helpful neighbor attempting his own repair: "Oh...I found another loose screw, I better tighten them all down or this might...
-
I guess they thought they needed to be tightened down because they were installing a new carb?!!??? Only line of reasoning that’s makes...
-
pbillyi69 replied to the thread What's on your bench?.on my bench today was the neigbors ryobi bp42 leaf blower. he said he put a new carburetor on it and it wouldnt run. gas was leaking...
-
I’m one of the founding members of CSSA! But I’m usually too busy sniffing two stroke oil to attend the meetings.🤣
-
And he'll touch you anyway to check if you're telling the truth 😎
-
pbillyi69 replied to the thread What oil is best? and what ratio?.im a thermal engineer too....its hot dont touch it or you will get burned. its cooled off. now you can touch it.
-
Well finally finished up the last of my VP oil and just mixed my first 5 gallons of dominator at 32:1 :cool:
-
We build a lot of automobile engines....and need a floor that's stout enough to roll an engine stand around on.
-
I've never had a problem. you could also make sure the piston closed off the port if you are worried. a stopper or plug isn't a...
-
pbillyi69 replied to the thread Show off your muffler mods.if you get the bigger mesh screen they work pretty good and dont hinder performance at all.
-
pbillyi69 replied to the thread simington grinder.i have one of his chain rails too
-
https://luckydogmfg.com/
-
This $220, filthy faded screamer has a muffler that is so rusted, you can't remove the bolts. Stripped out trying. Gobs of compression...
