pavel408's latest activity
-
Maybe just a typo on their part. 450X and 445S specs are on Husqvarna Germany. 450S and 445S specs are on Husqvarna Norway... -
pavel408 replied to the thread Husqvarna 564xp (g) fuel inject.Yep. Or maybe it is just a mistake in the pre-release specification :nusenuse:
-
pavel408 replied to the thread Husqvarna 564xp (g) fuel inject.Actually 450X, 450S, 445S. And what is interesting that all 3 are announced with 50,2 cc engine.
-
Outboards don’t trap bar oil either. Bar oil in the clutch drum contributes to clutch overheat and bearing failure.
-
the muffler is a open can. I like how u can mod the muffler outlet under the deflector. U don’t need a second one. The exhaust has a...
-
The air filter is from the 462 not from the 362/old 400.
-
The big clutch cover from 462 /500i will fit perfectly. But the dogs won’t line up. The outer dogs from the normal 064/044 set are about...
-
Here is one of my most used saws. A crew saw my main saw. This is one that is a daily runner in the most demanding weather, wood and...
-
You put it in G rated terms..............I struggle with that. I just got off the phone with a sales lady. I was trying to be as nice as...
-
It looks like I skipped over installing the flywheel as well. I chose to do a timing advance on this saw when installing the flywheel...
-
The next part is to check the squish. If you are using a factory cylinder and piston with a base gasket, you may decide to skip this...
-
The next step is to install the piston. Before installing, I like to drip a few drops of oil on the bearings in the bottom end. Get both...
-
The next step is to get the top end components ready for installation. I took my new caber rings and inserted one into the cylinder in...
-
Step 5: Install flywheel side crank seal and carrier On the older saws in this series (162, 266, 61, etc), Husqvarna used a plastic...
-
Step 4: Install oil pump/seal carrier assy On a 266, and other similar saws of the same era, Husqvarna integrated the oil pump and...
