pavel408's latest activity
-
The next part is to check the squish. If you are using a factory cylinder and piston with a base gasket, you may decide to skip this... -
The next step is to install the piston. Before installing, I like to drip a few drops of oil on the bearings in the bottom end. Get both...
-
The next step is to get the top end components ready for installation. I took my new caber rings and inserted one into the cylinder in...
-
Step 5: Install flywheel side crank seal and carrier On the older saws in this series (162, 266, 61, etc), Husqvarna used a plastic...
-
Step 4: Install oil pump/seal carrier assy On a 266, and other similar saws of the same era, Husqvarna integrated the oil pump and...
-
Step 3: Install clutch side case half, mate cases After making sure all sealing surfaces on the cases were good and clean, I laid down...
-
Step 2: Install crank assembly into flywheel side case half I cleaned up the bearing pocket on the flywheel side case half lightly with...
-
Ok, I'm back at it. I had a few saws to get done for other people in the time being - I rebuilt a 288 for a customer, converted an ms290...
-
The next step was to split the case. Remove the handle by removing the three screws on each side that thread into the AV mounts. Remove...
-
Next step was removing the flywheel. Remove the two 4mm hex head machine screws that retain the starter pawls and springs. Make sure not...
-
I use pieces of a two-jaw puller and some long studs from an 044 carb box housing to pull the flywheel off. Make sure you thread the nut...
-
Got the parts all spread out as well. The only thing that I appear to be missing is the starter cover mounting screws.
-
pavel408 reacted to Vintage Engine Repairs's post in the thread So what did you buy today with
Like.
I made a husky clutch removal tool. I have considered buying one, but I have a TIG welder and a bunch of old sockets and tooling I could... -
pavel408 reacted to mark davies's post in the thread Echo 620, 501 and 390 - Air Filter sucks and we need help with Like.
hi all yes im running the a2 designs filter upgrade on my 621sx its defiantly a worthy upgrade for the 590,620,621 model no particles...
-
Last 2 slabs r done, everything is cleaned up, and I'm shot. My Lil helper even looks tired. I think he ate too many ribs😂 yet he still...