Partner's latest activity
-
PCame in the mail today! Very excited to cut with it - maybe tomorrow?
-
PThey're probably just pulling that from https://arboristsite.com
-
PPartner replied to the thread Oil questions....And everything is clear 🤠👍 you can close this thread now 😉
-
PClean and color are not always the same thing. You have to rub it between your fingers and check for grit followed by a long sniff to...
-
PAgree. I wasn't concerned with what make of oil I ran in my oldest and most thrashed saw. Had it 20 years and hundreds of tanks ran...
-
PRegarding the p-100's I found that model easier to find parts for than the little 3 cubers ,500 and 5000 plus . .It did however take me...
-
PPartner replied to the thread Oil questions....In a diesel engine, the oil is clean only a short time after replacement 😎
-
PTry Motul 710
-
PPicked up this X21 today, very hard saw to find. Hope to find its missing muffler and gear cover when I go back for another load of saws.
-
PPartner replied to the thread Oil questions....I don't know if there is another oil on the shelf at the Stihl dealer 😎
-
PI think I’m going to be doing a 266 top end swap on my new-to-me white top 61.
-
PI just use this undiluted on a cue tip. The aluminum transfer foams up, the plating doesn’t.
-
PPartner replied to the thread So what did you buy today.Similarly, when cutting steel, one disc wears out slower and another one wears out faster 😉👍
-
PPartner replied to the thread So what did you buy today.I don't know about your current 😉 our largest 5" is 9.5A / It's not about power, but about operating time. A larger engine is less...
