Partner's latest activity
-
PJust about any aircooled oil is better snd cheaper than Ultra. You want to waste money on low quality, yet high priced crap, have at it.
-
PI’ll share it again for the guys that haven’t seen it. This is dominator at 32:1 in my ported 2153 after about 25 gallons of fuel. It...
-
PPartner replied to the thread So what did you buy today.Yes, but with other manufacturers the measurement 🟥 agrees with the caliper 😎👍
-
PIs it like a TV screen - measured on the diagonal?
-
PPartner replied to the thread Trimmer Lines Breaking Off Inside Speed Feed.In my opinion, the original nut in the spool 27-2 Stihl has too much play. If it weren't for the washer, it would rattle, I had to...
-
PPartner replied to the thread So what did you buy today.The 🟥 Stihl line has fake dimensions Take 2.7mm, you can use a caliper to measure 2.35mm, it's a size smaller and it's the same with...
-
PPartner replied to the thread Trimmer Lines Breaking Off Inside Speed Feed.The Chinese 10x1.25 adapter fits, you have to insert it the other way around. The key is less than 19mm The collar of the Chinese nut...
-
-
PPartner replied to the thread Partner Chain Saw Thread.This is a Swedish forum / chainsawcollectors. se
-
PPartner replied to the thread So what did you buy today.Someone wrote that they don't like large spools, so I bought smaller ones 😉👍 One is free
-
-
PPartner replied to the thread What oil is best? and what ratio?.I would recommend gear oil to him 😉 it lubricates the bearings better 👍
-
PIf I have not mentioned it before take note by using the bar plates for a 2100 Husqvarna the Husky bars are a perfect option rather...
-
PDuring the covid lock down I completely rebuilt two P100's ,A McCulloch branded sp1000 and a P-100 super .Using two damaged complete...
-
PGot tractor parts and replaced the starter ring gear. Pictures are of splitting it a couple days ago, classic torque limiter failure...
