Partner's latest activity
-
PPartner replied to the thread SOLO Solo thread.It could be 600 check Mike's website
-
PAnyone know what kind of little Solo this is? It was made in Western Germany so pre 1990 but thats alls I know about it. Came with a...
-
PPartner replied to the thread Trimmer Lines Breaking Off Inside Speed Feed.A bit of Dremel and I turned the guides to the other side because it was already very worn / Chinese maple 25-2 Stihl
-
-
PPartner reacted to edisto's post in the thread Trimmer Lines Breaking Off Inside Speed Feed with
Like.
6 years ago I bought a 3 pound spool of Husqvarna Titanium Force line. I have only used about 2 pounds of it and it still is pliable... -
PPartner replied to the thread Trimmer Lines Breaking Off Inside Speed Feed.I am adding an additional spring to the Chinese clone T25
-
-
PPartner replied to the thread The Swap Meet Thread.I'm about 500 km from the sea, I'd love to turn into amber 😎😉
-
-
PSpent six hours with a skid loader burning trash and filling a scrap roll off at the dead neighbors. Good stuff is going to auction...
-
PFollow-up on the pool cleaner repair: Replaced the servo motor and seal. Couldn’t get the motor to get past the self-test while on the...
-
PPartner replied to the thread So what did you buy today.Instead of an address, look for 6 states / there is one and we are Stan Borys 😉👍
-
PToday's haul......part of it.... Plus, dinner on the way home.
-
P"ghetto mart"...what kinda place is that...do tell?:confundio1:
-
PPartner replied to the thread What's on your bench?.You remove the oil pump drive ring together with the crankshaft bearing 😎👍
-
POr, an 020 :p
-
PWinding down the garden for the season. Picked last string beans and pulled the plants, same with cucumbers and finished trimming...
-
PJust built some fences for the truck bed, along with a saw holder “bracket.” All with old junk slab wood.
