Partner's latest activity
-
PPartner reacted to ray benson's post in the thread Trimmer Lines Breaking Off Inside Speed Feed with
Like.
Soak the trimmer line and check the metal eyelets where the line comes out of the head - don't want sharp edges. -
PLocal auction, saws and related stuff went pretty fast and I didn't quite get there in time for the first lots but I still ended up with...
-
PLike most small towns in the Midwest ours has a "festival" they call Watermelon Days. Not sure why since we don't actually produce any...
-
P394 cases and top end are assembled, passed vac and pressure test. But I had to use some moto seal around the clutch side crank seal...
-
PPartner replied to the thread So what did you do today?.Even though it's an old car with a lot of electronics on the steering wheel, a thief would have been able to start it in 2 minutes, but...
-
PThat or lots of knocking it off while limbing with a worn out bar?
-
PAs they say in a Mel Brookes movie..."It's alive!" Evidently someone lost or damaged the original air filter so they came up with a...
-
PWhile back I hit a deal on a 461 from David newbie on AS. Just got it from Kevin. My first one is ported for grunt, this one for speed...
-
PPartner replied to the thread What's on your bench?.Chain too big 😉👍
-
PTime to do the 394 cases. Look at that chain rash… I’ll probably drill the end of the crack and smear some JB weld on it.
-
PThe 254 runs! Still waiting on some parts though: clutch cover, bar plate, tensioner, switch block off plate, screws, and choke lever...
-
PPartner replied to the thread So what did you do today?.You don't want to spoil too much 😉 the mechanic doesn't have such dilemmas / I'll make a mod tomorrow because you can't turn the key...
-
PI recently had to pull a ford ignition that looked similar. It had small hole on the underside with a sprung catch. I pushed it up...
-
PPartner replied to the thread So what did you do today?.I almost got to the ignition switch 😎👍 Octavia II It is still held by 1 shear bolt
-
