Partner's latest activity
-
PThe .404 Oregon chain that I was running barely dulled at all after all the cutting. And it barely stretched, too. This is how little it...
-
PPausing for a water break and to let the saw cool down a bit. Here are the results so far of my first time milling.
-
PI put the feeler gauges needed into the bar groove then use a hammer and a flat surface to close them. Go slightly thinner than...
-
PPartner replied to the thread So what did you buy today.If you write so 😉👍 how much
-
PPartner replied to the thread Bar rail groove closers.I once had only one 1.5mm guide bar and the dealer gave me a 1.6mm chain but I had to return it because it was getting stuck.
-
PObviously I don't get out much, 60 years old and the only time I've ever heard the term Westfalia is
-
PPartner replied to the thread So what did you buy today.The switch is good 👍 the engine starts only after a moment of consideration 😉 there is an RL lever above the switch, but in this model...
-
PLoaded up and hauled some giant Russian Olive mill logs to my house, with the help of a friend’s liftgate-equipped truck. Looking...
-
PPartner replied to the thread HUSQVARNA HUSQVARNA THREAD.An overheated clutch spring causes the clutch to engage earlier
-
PA Pioneer P-50 left the bench and a Homelite 900D took it's place.
-
PPartner replied to the thread So what did you buy today.Today such a patient costs $5 😎👍38 years old, quiet for now, I have never seen a speed sensor on the fan in a drill. Faulty cable? That...
-
-
PI felt like the vitrified wheels loaded up or glazed over very easily leading to overheating of the chains. Grinding seems to be pretty...
-
PPartner replied to the thread So what did you buy today.I'll take a few pieces for now
-
PPartner replied to the thread So what did you buy today.Bill just like everything else 😉
-
PPartner replied to the thread So what did you buy today.I would buy this 4.0mm 5/32" wheel, but it is not available here
