Partner's latest activity
-
PI tried to get an f150 tailgate but ended up with all of this plus some other stuff. I got all four wheels. I’m $560 into it all and...
-
PPartner replied to the thread What's on your bench?.It's easier to remove the cylinder 😉 I don't have an endoscope. I think you need to do this to see if there is any coal
-
PPartner replied to the thread What's on your bench?.The channels are in front of the plate on both sides / I wonder if there is something under this plate / I can't unscrew it
-
PLooks like a stuffer to reduce cold air volume and direct the flow for a proper scavenge loop. The reed probably provides too much...
-
PPartner reacted to heimannm's post in the thread Resolved SERVER OUTAGE - Godaddy Strikes Again with
Haha.
-
PPartner replied to the thread What's on your bench?.It seems that the screw is glued well, someone tried to unscrew it earlier / I also wanted to look under it
-
PPartner replied to the thread What's on your bench?.There is also a reed valve that cannot be reversed because it is not symmetrical
-
-
PThe parts list calls it a cap. It doesn't seem to serve much purpose.
-
PPartner replied to the thread What's on your bench?.What is this sheet under the + screw? Kawasaki KBH 35A
-
-
PI just needed a simple non radial arm saw so I ordered this. https://www.amazon.com/Metabo-HPT-C10FCGS-Compound-15-Amp/dp/B07PX44JQM
-
PPartner replied to the thread So what did you buy today.This is an interesting Walbro set 👍 show it better 😎
-
PTor - you will find that little slide hammer quite useful if you work on many older carburetors and need to replace the nozzle check...
-
PSince I already ordered the LRB piston for the 451E I got started on getting this 451EV cleaned so I can prepare it for the display as...
-
PWhile rummaging around in my garage today I was reminded of another small Jonsereds up on the shelves, turned out to be another 451. An...
