Partner's latest activity
-
PPartner replied to the thread So what did you buy today.Really good line, although not cheap, about $20
-
-
PHere is a cast iron pan I found at the dump. I took a shot of it after an overnight dip
-
PI dug this out of a house that was being demolished along with a few others. The owner wouldn’t go in because they thought there were...
-
PFriday's purchase. I've outgrown my 7x12 landscape trailer so I bought a 7x18 7K car hauler. 2024 AMO for less than $3900 on the road...
-
PI wouldn't bother trying that, there are enough saw bodies out there to get a good crank from. The most important thing is to know if...
-
PPartner replied to the thread The Husky 42/42 special/242/246 thread.I wonder if the red glue would hold it, I'm just curious
-
PPartner replied to the thread The Husky 42/42 special/242/246 thread.As long as the crankshaft holds its dimensions
-
PGot the other junk 261 going. Waiting for the cylinder shroud and need to order a top of the handle. My 261 parts stash is getting bare...
-
PGrabbed a set of these bars. They weren’t available for a few years that I could find. I have the short ones with a point on the other...
-
PFirst go at porting is off the bench. Before it was turning 11k in 16 inch hardwood with the same 24" bar with full chisel .050 rakers...
-
PI use the bernzomatic ts4000 Mapp gas tip
-
PPartner replied to the thread Show off your muffler mods.I have a burner like this, only with a small thread for cans that are more popular in Europe / I'll see what the symbol is/ German but...
-
-
P088 rebuild complete. Edited down to get to the point...
-
PPartner replied to the thread So what did you buy today.Not always / see the power of the 120v and 230v welding machine
-
PMessing with the 461. Had given up on the pipe thinking it made it super finicky. Turned out carb was gunked up now shes solid purring...
