Partner's latest activity
-
PYes they are. 30” blades with around 1,100lbs of downforce on each of them. Makes my 500hp tractor bark a bit. “At least...
-
PPartner replied to the thread What's on your bench?.They say that open rust preserves sheet metal 🤨🤷♂️
-
PThat'll buff right out.
-
PI ordered a couple of these hand made in El Salvador condor knives I have the larger low drag version and it's my favorite large knife...
-
PBought a junked out filthily T540xp of eBay for $71.00 shipped It was said to have low compression, and the break handle is snapped...
-
PPartner replied to the thread What's on your bench?.It's Pacer on steroids 😉👍
-
PWorking on a buddies ms310. Scored bad. Complete tear down. Oh I love working on Stihls🤣 I have a deep resect for guys that are hard...
-
PGot the 064 all stripped down and mostly cleaned up, had a little damage to the front part of the case, not leaking though, it has been...
-
P1972 AMC Javelin. Roached but very solid. Plan to build it to race in the 24 Hours of LeMons...
-
PThe custom rear AV may just double the value of that saw Dan. Last week a fellow walked in to my shop looking for some black iron...
-
PThat's a 90 with the compression release on the top . Ernie
-
PAt a neighbor's shop I stumbled across an 81 or 801 I've seen before but thought was long gone, complete with a full wrap and H & S...
-
PPartner replied to the thread What's on your bench?.I found 2 pieces in a pile of other things and at first I didn't know what they were, but they looked good and were signed
-
PDidn't take a before pic. Surprisingly the transfer was not horrible. It was very light, not super thick or really bonded if that makes...
