Recent content by Painlessjoe

Yes me too! I always liked the little 024 supers but I didn’t notice that little switch and when I saw the generator coil behind the flywheel I was surprised

Yes a little brass looking switch by the carb adjust holes

I didn’t know it was a heated version until I took it apart to clean and put a coil in

You never fail until you stop trying

Ok, thanks for the replies on my earlier post ,so I put new factory cyl piston kit in place of the am that failed which was refunded by the vendor I got it from .good business. And comparing the two you guys were spot on the am port openings where flat across top and bottom so I can see why the...

Thanks for the input got a new Stihl cyl kit on the way from dealer for 270 never bought a new oem cyl before only good used with never an issue and all of those are working fine . More later.

Nope arrow to exhaust, 40:1 vp oil 74 main jet in wj 69 ,new oem seals, bearings base gasket with a little 518 approximately .030 squish all new rubber as well vac pressure test before first start even ran a little fine emery by hand around the port openings . Really tried to be meticulous...

Trying to figure out how to put pics on here I’m not very good at navigating those kind of things yet and well ... yes it was a cross . By no means bashing though.

Hello everyone first thank you for accepting me to this wonderful site that has been a wealth of knowledge and interest. Hopefully I can add something positive to the site and it’s members. Ok so I got a wiped out 660 from friend who runs a tree service to get back in service for him . Bad cyl...