PA Dan's latest activity
-
Need New batteries in Your Hearing Aids? I am with @Stump Shot with the Gasket DisOrder. One phone call can disrupt the simplest of... -
I knew one friend was looking for a 2101XP, and another was looking for a 390XP. I found this seller who had both. Turns out, he also...
-
Tip- Soak gaskets in fuel mix prior just to installation so they will swell and seal as well as make sure they are on the proper side of...
-
PA Dan replied to the thread Cheap scored 357XP.What he said!👆
-
We're gonna need some pics
-
PA Dan reacted to huskihl's post in the thread Preparing to port first saw - which one, and what method? with
Like.
It needs the transfers raised 4° in order to get those RPMs back. -
Most Echos won’t benefit from it as they already have aggressive timing.
-
5-10 degrees depending on the saw
-
yes yes
-
PA Dan replied to the thread Small saw timing advance.I do. Once you have done a couple the effort isnt much. If you do it and the saw doesn't like it you can always move it back to stock...
-
I read lots of posts about timing advances on 50cc saws and larger. Do people advance the timing on smaller 30-40cc saws? Does it...
-
Randy really set a standard of generosity here, with information, spare parts, or whatever. I like to think that I learned a little from...
-
Randy was notoriously generous with porting numbers. In fact, he poasted 357 numbers in numerous threads. Right there in broad daylight...
-
Early this year I put together a 359 cyl. on a 357 bottom, I inquired here about porting #s and stuff and pretty much followed advice...
-
Don’t waste your time trying to clean up an aftermarket cylinder. Just not worth it for what you can buy a new one for. If it was an oem...