Outback's latest activity
-
Outback replied to the thread Husqvarna 564xp (g) fuel inject.When you do the math on the batteries and there life span. Electric cars have a larger carbon footprint than gas ones. The more range... -
Outback replied to the thread Fix Your Inaccurate Compression Tester.Sometimes my shrader valve gets sticky and reads low. When a good saw reads low I pull the shrader and wash it in gas and then the...
-
Outback replied to the thread Ancient Homelite Super 2 Identification.Acres says its a Oregon A061 bar mount. https://www.acresinternet.com/cscc.nsf/BMP/12?OpenDocument Here's one on ebay for $25...
-
Outback replied to the thread 261 with a Farm Boss bar?.Boss of the farm is better than being the bar light weight.
-
Outback replied to the thread Chainsaw Bandit.That's easy, the picture is obviously DJ Khaled. More concerning is teenage stoner arrested with a 3d printer for buying switches and...
-
Outback replied to the thread Stihl 400 point one predictions?.The two things I noticed from that video is the stock intake horn looks considerably less restrictive. It also sounds like the 400.1 is...
-
Outback replied to the thread Crank bearing installation question.Yea, you have to pull the plastic. I have an oven in my barn. I leave the cases in the oven for 30 minutes, sometimes more so it bakes...
-
Outback replied to the thread Crank bearing installation question.Yep, I keep a bottle of whatever 2t oil I've gotten with other saws purchases that I don't want to use for mix on the bench and pour a...
-
Outback replied to the thread Crank bearing installation question.The old stihl manual had a procedure for cold bearing install too and I heard several people tell me that when they replaced the...
-
Outback replied to the thread Crank bearing installation question.400f in the barn oven with welding gloves. Bearings fall out and in. Couldn't be easier. Service manuals said 200c in the stihl and...
-
Outback replied to the thread So what did you do today?.Your Furboss looks unimpressed.
-
Outback replied to the thread What's on your bench?.I've seen sparks piss reving a ms261 at night to get the mtronic to reset. It sent a pretty solid stream out. It was a high hour saw...
-
Outback replied to the thread Hybrid clonesaw 365 with a 390 topend - aka the "86'r from youtube".If that's the case I would say that less is more as regards the intake timing. Keep that primary compression up as high as you can.
-
Outback replied to the thread Hybrid clonesaw 365 with a 390 topend - aka the "86'r from youtube".The crank looks off center, Its probably just the angle of the picture. When I drop the crank in a hot case and bearing I put a feeler...
-
Outback replied to the thread HELP! Husqvarna 440e.There irritating to tune. Initial settings are L 2 1/2 turns out and H is 2 turns out. If you need to make it richer or leaner try...