Onan18's latest activity
-
https://www.ebay.com/itm/365272307516 Cheap OEM carbs -
-
And since I had all the gear out I decided that 3 months after it hit the bench for a muff mod I'd do the same for my S&S 346. Full...
-
Onan18 replied to the thread Gun range 2022,2023,2024,2025.Took my SA-35 Hi-Power to the range today, ran 100 rounds of Winchester Target &Practice through it, ran flawlessly. The gun shoots...
-
266se getting a ground up rebuild. SKFs installed. Cranks in. Got it tore down and cleaned up this past week.
-
Husky 40, good condition for being from 1978. Will have a little check up on it, replace a few parts, considering keeping it...
-
I haven't looked at this 444SG - 1984, for 6-8 years, figured I'd do what I was planning to do at the time. Now it got a new oem fuel...
-
All together again. I did give it a prime and it fired right up, but with the condition of the fuel tank I don't think I will bother...
-
All cleaned up and going back together...we had to make a couple of gaskets for the pieces that connect the engine to the shaft housing...
-
Needs a good cleaning and inspection. We will have to make a few gaskets on the way back together since some were torn during...
-
Nice 285CD , new seals and carb kit
-
Do I win for most carbon plugged exhaust port? Junkyard Echo SRM2620. Got it cleaned up and it runs good now!
-
Another lump of old metal followed me home. It's a vintage 'lightweight' Brown & Sharpe six inch dividing head. It will need a bit of...
-
Yes.........
-
$31.97 is still a heck of a good deal. I have done well with Home Depot. In the Fall of 2022 one of my texted me a link where Home Depot...
