Recent content by Olds120

Thanks for the information

Any idea of the value?

I found this Reed-Prentice Corp saw at a friends. Anybody know about these?

Ground down a 19mm socket to remove a stubborn 262xp clutch, cleaned it up and replaced the spring now the chain doesn’t spin at idle 👌

More pics

I did my 1st piston swap today. I did it on a Husqvarna 261with a 262xp meteor piston/caber ring. Modded the oem muffler after soaking in evaporust and painting by opening up the side holes under the screen also enlarged the hole behind the front mounting bracket/enlarged the factory slit. Also...

Mahle and a 120

I got this 262xp today for $367. Seller said it would start but run rough thought it needed carb kit. It was filthy so it took it apart and cleaned it up, put a new seal collar, adjusted the carb H/L 1 1/4 each put little fuel it popped 2 pulls started next pull. Runs oils idles. Piston still...

6.0 bulletproofed

I bought this 2005 F550 for the farm

Picked up this 1990 262xp with a scored am cylinder and an HDA87 carb, also came with a new am piston/cylinder kit which I wont install which someone paid $112 for in 2016.

Thanks for the reply, good thing I didn't return them yet.

can someone help identify the correct part # for the anti vibe buffer I think it is called the goes in the frontmost part of fuel tank/handle opposite the spring on a 1991 262xp? The only part # I can find is 503524101 see below problem is it is smaller than the broken part I removed see next...

Plowed another 10” of snow

Got to use my new mastermind 372xp oe for the 1st time on some ash firewood….. that saw is awesome 😎