old guy's latest activity
-
old guy replied to the thread Husqvarna 350 build thread.This was probably 5 years ago, I don't remember the details, maybe one I put a 346 on. I have at least 3 of those blocks in parts bin... -
old guy replied to the thread Husqvarna 350 build thread.On the last one I did you are right, .017 with base gasket delete.
-
old guy replied to the thread Husqvarna 350 build thread.I do not have a mill, but I can get what ever squish I want with those bearing blocks by using 80 grit wet r dry on a flat surface &...
-
old guy reacted to Wolverine's post in the thread Simington / Silvey Square Chain Grinders Tips/Tricks/Secrets with
Like.
-
old guy replied to the thread Husqvarna 350 build thread.I have not had any of those come loose. (4 of em) By this I mean I have not had a 357-359 come loose without the support.
-
Great thread. I know of at least three bearing cups. The oldest had coursed threads on the cylinder and the crankcase screws. Then came...
-
old guy reacted to farminkarman's post in the thread SOLD Husqvarna 350/351 44mm cylinder with Like.
I haven’t ever ported one. I ran one that had a gasket delete, and it wasn’t terrible. Certainly not in the same league as a ported 346.
-
old guy replied to the thread Husqvarna 350 build thread.Yep, I do that too!
-
One of my favorite 350 mods using a part that I stole from a 353 and mounted on a 350 with muff mounts that kept loosening up. I cut off...
-
This feels like a good time to bring up: using aftermarket parts in this bottom end setup can really shake up a build. I've never...
-
old guy replied to the thread Husqvarna 350 build thread.Oh, I have a small pile of those, I think only one left with the stock dished piston. A couple of them are now 346s. Some of these are...
-
There is definitely value in taking some time to modify the stock 350 for a low-buck rig. If you have run a good ported 346xp, you can...
-
Alright gang, sounds like there is enough interest in a thread on building husky 350's and their related plastic-cased variants (Husky...
-
They all get used!
-
Don't forget to put the clutch cover back on when testing the saw, don't want a clutch to come loose and spin off of the saw at great...