oddsaws's latest activity
-
Today's haul......part of it.... Plus, dinner on the way home. -
Just built some fences for the truck bed, along with a saw holder “bracket.” All with old junk slab wood.
-
oddsaws replied to the thread So what did you buy today.Facebook finds today - a 359 runner and a 372xp XT parts saw
-
oddsaws reacted to John Wargo's post in the thread Not so pros 4 new and without politics or drama with
Like.
Not quite as comfy as the blue jeans that i normally wear. But it should be fun today. -
Husqvarna 357xp. Hopefully it runs
-
oddsaws reacted to Czed's post in the thread Not so pros 4 new and without politics or drama with Like.
to
-
So instead of trying to reused the steel line I made some fittings and used some good rubber tubing. I found the bar clamp but...
-
I've been working on getting the Clinton CS424 back together, see post 35,543 for the beginning of this project. According to Acres...
-
Chlorine did a number on it. Pool tech told me those things will last if you only have them in when you run them but if you leave them...
-
It must be like this because the liquid is outside in this case. This is the case with a better water pump or outboard motor
-
oddsaws replied to the thread So what did you do today?.Last night I made a surround that I can use around my chain sharpener and vise. Made out of a sheet of hvac duct. This will hopefully...
-
-
-
oddsaws replied to the thread What's on your bench?.Not sure on that one. The motor casing did not appear to have any signs of a leak. The seal is installed with the back side of it...
-
-
Do you know if they leave it in the pool 24/7 or only when they run it?
-
oddsaws replied to the thread What's on your bench?.The complete servo unit looks like this and will have a new board inside.
-
