oddsaws's latest activity
-
oddsaws replied to the thread The 2025 346xp Porting Thread.Revisited this saw over the weekend. I did the work sometime back in March this year. At the time I didn’t have a right-angle tool to... -
-
oddsaws replied to the thread Not so pros 4 new and without politics or drama.Morning everyone. Was a busy day yesterday in the saw garage. Currently 79F, still humid but tolerable. Spending Sunday doing chores...
-
Heat up Pork shoulder Pupper kept watch, well kinda
-
oddsaws reacted to lehman live edge slab's post in the thread STIHL The Official Stihl Chainsaws Thread with
Like.
Kinda different looking -
oddsaws reacted to Woodslasher's post in the thread STIHL The Official Stihl Chainsaws Thread with Like.
I think Stihl proprietary bearings are made by F A G typically, fwiw.
-
No, In the past I have found that to be a odd size but lately that is what folks ask about.
-
oddsaws replied to the thread Aftermarket Rancher clutch covers.
-
-
I'm embarrassingly far behind on projects, but I hope to remove the tensioner from my 346xp soon and try them both out.
-
-
oddsaws replied to the thread What's on your bench?.W1, W2, and W3 for the 357 builds. I’m sure there is a thread somewhere discussing any differences. All measure 0.029” squish without a...
-
-
oddsaws replied to the thread Husqvarna 564xp (g) fuel inject.I just want to know if it’s going to reduce my carbon footprint ☺️
-
oddsaws reacted to lehman live edge slab's post in the thread Husqvarna 564xp (g) fuel inject with Like.
But the question on everyone on YouTubes mind is it fuel efficient? 🤣
-
-
oddsaws replied to the thread Not so pros 4 new and without politics or drama.Afternoon gentlemen. It’s a hot one out there. The daily grind is done and it’s time to shift the focus to all these saw projects piling up.
-
oddsaws reacted to cuinrearview's post in the thread FOUND IT Husqvarna 353 346xp top cover no primer with
Haha.
Shoulda built a red one...
