oddsaws's latest activity
-
Heat up Pork shoulder Pupper kept watch, well kinda -
oddsaws reacted to lehman live edge slab's post in the thread STIHL The Official Stihl Chainsaws Thread with
Like.
Kinda different looking -
oddsaws reacted to Woodslasher's post in the thread STIHL The Official Stihl Chainsaws Thread with Like.
I think Stihl proprietary bearings are made by F A G typically, fwiw.
-
No, In the past I have found that to be a odd size but lately that is what folks ask about.
-
oddsaws replied to the thread Aftermarket Rancher clutch covers.
-
-
I'm embarrassingly far behind on projects, but I hope to remove the tensioner from my 346xp soon and try them both out.
-
-
oddsaws replied to the thread What's on your bench?.W1, W2, and W3 for the 357 builds. I’m sure there is a thread somewhere discussing any differences. All measure 0.029” squish without a...
-
-
oddsaws replied to the thread Husqvarna 564xp (g) fuel inject.I just want to know if it’s going to reduce my carbon footprint ☺️
-
oddsaws reacted to lehman live edge slab's post in the thread Husqvarna 564xp (g) fuel inject with Like.
But the question on everyone on YouTubes mind is it fuel efficient? 🤣
-
-
oddsaws replied to the thread Not so pros 4 new and without politics or drama.Afternoon gentlemen. It’s a hot one out there. The daily grind is done and it’s time to shift the focus to all these saw projects piling up.
-
oddsaws reacted to cuinrearview's post in the thread FOUND IT Husqvarna 353 346xp top cover no primer with
Haha.
Shoulda built a red one... -
oddsaws reacted to heimannm's post in the thread STIHL The Official Stihl Chainsaws Thread with Like.
Andy (Lakeside53) had an excellent description of the process using home made tools etc, unfortunately the photos were lost in a hack...
-
oddsaws replied to the thread STIHL The Official Stihl Chainsaws Thread.I don’t think the case bolts will be long enough to pull the extra width of the crank + bearing. Perhaps check a local auto parts store...
