Recent content by Nate.

Yea… seller doesn’t show very good feedback. Have you opened a claim with eBay? I would at least try. If they get enough complaints about the guy at some point they will take notice.

Would you mind sharing the sellers username?

Already sent him a PM 😉

https://www.facebook.com/marketplace/item/1350013932820270/?mibextid=wwXIfr

It just so happens I have a ultrasonic cleaner for occasions like this

Alright, here is the update from today! Pulled carb & cleaned it, everything looked okay inside. Pulled and replaced both crank seals because they felt brittle even though it held pressure/vac. The problem persisted so I finally swapped an old carb on that has a very touchy low speed needle. The...

That is exactly what this saw does!

Appreciate the answers guys! I will pressure/vac test it when I get the carb off. The in tank fuel filter is new along with the fuel line. Crank seals are a very real possibility as this is a high hour saw that’s been run hard and rarely maintained.

it does seem to me like it runs outa fuel at the top end…

I can richen the saw down to like 10k rpm and it will still start screaming after a couple seconds at wot. My first thought would be fuel line but it’s brand new along with the fuel filter so I think I’ll go for a carb tune up.

Copy, I’ll go after the fuel system & see what turns up.

I’ve got an issue with my dad’s ms360. Saw runs the way it should except when I pin it wide open. It will 4 stroke normally for 2-3 seconds then lean out and start screaming. Anyone run into this? Thought I’d check with you guys before I start pulling it apart. Best Regards, Nathan

I have 28” light bars with skip chain on 2 of my 044’s. They feel good & don’t seem to have an issue with oil however most of what I cut is green wood.

These have been spoken for! I’ve got these 562xp case half’s & crank. Nothing wrong with them that I can tell. I just installed a short block.

Steps have been taken to remedy that situation 😂. Seems to run great with fresh gas 🤷‍♂️