MustangMike's latest activity
-
What is a TWI? -
Good morning fellas. I'm seeking a few 395XP parts. I need a good clutch, a crankshaft, and a PTO side case half. Have parts to...
-
MustangMike replied to the thread SOLD Stihl 440 w/ported 044 slant fin cylinder.Wow, great price for what it has. If I did not already have 17 running saws, including a great running 10mm 044 (that I purchased new)...
-
MustangMike replied to the thread Post up your ported cylinder Artwork.My friend Harold and I also revived 2 Stihl Pro saws today. Harold installed a spark plug insert in a MS461 that had stripped, and I did...
-
-
An old trick for easily flattening out the upper transfers and also squaring the corners is to use a couple stacked dremel type abrasive...
-
If You were to receive this as a gift from Your younger sister, would it indicate that she loves You or hates Your guts? :thinking: I...
-
MustangMike reacted to Mastermind's post in the thread Post up your ported cylinder Artwork with
Like.
The first cylinder I ever "ported" was done with a broken piece of round file in a drill. -
MustangMike reacted to SOS Ridgerider's post in the thread Dolmar 64xx/73xx/79xx series, smurfs and solo 665/675/681 thread with Like.
I use mechanical a lot as well, but this one is brand new, so I had to show it off. Lol
-
Thanks, will try that next time.
-
MustangMike replied to the thread Dolmar 64xx/73xx/79xx series, smurfs and solo 665/675/681 thread.I have always used my mechanical Craftsman calipers ... never needs a battery!
-
MustangMike reacted to SOS Ridgerider's post in the thread Dolmar 64xx/73xx/79xx series, smurfs and solo 665/675/681 thread with Like.
I wonder where they went…?
-
MustangMike reacted to Mastermind's post in the thread Post up your ported cylinder Artwork with Like.
I don't use anything on the diamond burrs.
-
MustangMike replied to the thread Post up your ported cylinder Artwork.I know that OEM plating is generally harder than AM plating, but I would practice on an AM cylinder before ruining an OEM cylinder...
-
MustangMike reacted to Mastermind's post in the thread Post up your ported cylinder Artwork with Like.
I use these. https://ebay.us/m/5W2RYt Takes practice. Start on the left side. Wide open. Straight up to the stopping point.
-
Whats best method for removing the bulk of material on top transfers? I've experimented with a few cutters on my right angle handpiece...
