millerlite's latest activity
-
Mmillerlite replied to the thread Rich coming off of WOT.I took a punch and folded the idle hole half shut and the same with the first transition hole. Beat a new plug in there and set the...
-
MHonestly I’d try another carb before I went too crazy. You know it is in the carb bc the old one works.
-
Mmillerlite replied to the thread Rich coming off of WOT.Im liking this discussion. My biggest problem in life is i always need to know why. Another carb might solve the issue, but why? What is...
-
MIt seems to me somewhere, in the case of the bigger carburetor, excess fuel (in comparison to a stock carb) must remain after the...
-
Mmillerlite reacted to Lone Wolf's post in the thread Stihl 200T - what is the best carb for it? with
Like.
He did test the engine for leaks already . "I was brought a 200T that "just don't run right." I ripped it apart and did a... -
Mmillerlite replied to the thread Rich coming off of WOT.Thats what I thought. And these are all good points. I have already checked all these things. Ive ran into carb issues before but not...
-
Mmillerlite replied to the thread Rich coming off of WOT.What should the pressure be? What is the effect of pressure vs lever height?
-
Mmillerlite replied to the thread Rich coming off of WOT.Pop off at 13 to 14 psi
-
Mmillerlite replied to the thread Rich coming off of WOT.Makes sense. Pop pressure i am not sure. I can test it later. For reference, on my mildly ported cs400 my settings are 3t out on high...
-
MMoved it for you. I'm a little biased (ok, a lot biased) towards China saws. So I'm gonna blame that for the issues.
-
Mmillerlite replied to the thread Rich coming off of WOT.If the check valve wasnt sealing wouldnt this cause a lean condition and not a rich one? I punched it out of the carb, checked it, and...
-
Mmillerlite replied to the thread Rich coming off of WOT.Thanks guys, the china saw is not the problem, it ran great besides expected power, till i put a wt9×× (whatever cs400) carb on it. Now...
-
MSo first ill explain the problem, then the backstory. Nomatter the state of tune, the saw dies coming out of a cut. The high is tuned...
-
Mmillerlite replied to the thread Unlimited Coils.I really like this little saw. Is there no coil that can swap over? I guess I just need something that has the same magnet spacing and...
-
Mmillerlite replied to the thread Unlimited Coils.I set it to hit the limiter and then dialed it in a bit tuning it in the cut. The saw is a strong runner right now, numbers are almost...