High Quality Chainsaw Bars Husqvarna Toys Hockfire Saws

millerlite's latest activity

  • M
    millerlite reacted to Mastermind's post in the thread Rich coming off of WOT with Like Like.
    Moved it for you. I'm a little biased (ok, a lot biased) towards China saws. So I'm gonna blame that for the issues.
  • M
    millerlite replied to the thread Rich coming off of WOT.
    If the check valve wasnt sealing wouldnt this cause a lean condition and not a rich one? I punched it out of the carb, checked it, and...
  • M
    millerlite replied to the thread Rich coming off of WOT.
    Thanks guys, the china saw is not the problem, it ran great besides expected power, till i put a wt9×× (whatever cs400) carb on it. Now...
  • M
    millerlite posted the thread Rich coming off of WOT in Chainsaws.
    So first ill explain the problem, then the backstory. Nomatter the state of tune, the saw dies coming out of a cut. The high is tuned...
  • M
    millerlite replied to the thread Unlimited Coils.
    I really like this little saw. Is there no coil that can swap over? I guess I just need something that has the same magnet spacing and...
  • M
    millerlite replied to the thread Unlimited Coils.
    I set it to hit the limiter and then dialed it in a bit tuning it in the cut. The saw is a strong runner right now, numbers are almost...
  • M
    millerlite reacted to Duane(Pa)'s post in the thread Unlimited Coils with Like Like.
    @Red97 Any information for this fella? I know you play with a good many Echos.
  • M
    millerlite reacted to EFSM's post in the thread Unlimited Coils with Like Like.
    If I remember correctly, these are limited to the lower 13k range. However, if the saw is running lean, blipping the throttle repeatedly...
  • M
    millerlite replied to the thread Unlimited Coils.
    Has anyone tried the china coils? What about a coil off of a 4910?
  • M
    millerlite posted the thread Unlimited Coils in Technical Area.
    Hi Folks, I'm new here from Canada. Bit of a saw addict, just aquired a CS400 echo. Seems like a nice little saw. Tuning it in and...
Show older items
Top