mgr1's latest activity
-
mgr1 replied to the thread WANTED A Dolmar 152/153 Crankshaft..Post some pics please -
Frank - if you want to post a picture, I'll bet we can help ID them.
-
mgr1 reacted to upstateamish's post in the thread Hybrid clonesaw 365 with a 390 topend - aka the "86'r from youtube" with
Like.
3rd run, getting it tuned in a bit more, I think I've almost go it dialed in so it will rev and won't die after sitting at idle for a... -
mgr1 reacted to Powerstroke Cowboy's post in the thread WANTED A Dolmar 152/153 Crankshaft. with Like.
I am looking to see if they can be made to fit in a 123/133/143 series saw. Yes, the 152 has a bigger shaft on the PTO side. That could...
-
mgr1 replied to the thread WANTED A Dolmar 152/153 Crankshaft..What You gonna build? 152 & 153 have a different pto side diameter.
-
mgr1 reacted to Powerstroke Cowboy's post in the thread WANTED A Dolmar 152/153 Crankshaft. with Like.
Howdy all, I'm looking for a Dolmar 152 or 153 Crankshaft. If you have one you want to part with, give me a shout. Also, if you...
-
mgr1 replied to the thread What's on your bench?.The mx stands for modified extra. Plastic fuel tank with a bigger capacity for fuel. The only week part of the 143 is the 2 piece...
-
mgr1 reacted to old_sir_henry's post in the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread with Like.
Lately I have found two 115 in the same town I live in. One saw is a SACHS-DOLMAR 115 built 1987 and the second is from 2014...
-
mgr1 reacted to upstateamish's post in the thread Hybrid clonesaw 365 with a 390 topend - aka the "86'r from youtube" with Like.
Rough measuring showed the connecting rod sits about 1.5mm below the end of the crank lobe at BDC. as I got into it, it turns out I did...
-
New thin ring setup,
-
One more.
-
mgr1 replied to the thread customchainsawparts.All the ipl's I have, nothing to find with that partnr.
-
mgr1 replied to the thread customchainsawparts.Are those bars oem Sachs Dolmar?
-
mgr1 reacted to upstateamish's post in the thread Hybrid clonesaw 365 with a 390 topend - aka the "86'r from youtube" with Like.
Last night I pulled the exhaust off to check out the piston (still looks good to me) and opened up the exhaust. Heat cycled it for...
-
mgr1 reacted to upstateamish's post in the thread Hybrid clonesaw 365 with a 390 topend - aka the "86'r from youtube" with Like.
Ok, some tweaking of the carb and it runs! (and honestly, I think pretty good) but the temp is dropping and it's super windy in just a...