Don't waste your time with ironhorse pipes and don't lower the lower transfers any further than what you've shown you're learning so don't feel like you have to get everything perfect the first go around if you're exhaust is 105 it should make good torque for a work saw just remember bevel...
Found something in the drawer of my tool box that wound up being what the Dr ordered. Ones I made the gasket I just peeled the stiker off and the gasket measured .006 perfect. Thanks summit racing for saving me one's again.😆
.005 -.008 right now I have three base gaskets that all but one are .019 and the one on the saw right now is .017 squish is at .35 without base gasket she was a little tight I would cut squish But I don't want to move the intake timing down that far so a base gasket that's around .005 - .008...
Best Stihl saws well depends on what demanda you going to be asking it to do "f" the new carp from any saw company and think of it this way there's a lot of older saws out there that still run as good as they did when new I personally think the best Stihl saws ever made and all around all...
So after running my 372 clone side by side with the 365 with the big bore both saws ported by me obviously I'm going to be putting a 50mm top end on the 365 all tho it runs very consistent and very well but so does the 372 and it has way more grunt than the 365 with the big bore.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.