Max the Mac Man's latest activity
-
Max the Mac Man reacted to cinci5's post in the thread MCCULLOCH The official McCulloch thread with
Like.
If you remember there was a short period of time 1975-1982 that the US was converting over to metric system, due to President Ford... -
Max the Mac Man reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with Like.
I was putting a PM800 together and learned a valuable lesson about the dowel pin (110851) used to locate the bearing insert on the PTO...
-
Max the Mac Man replied to the thread MCCULLOCH The official McCulloch thread.Will be bringing a few to test to Randy's.
-
Max the Mac Man reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with Like.
Many of the black, SEM coils came to me mixed together, and in a few instances had incorrect part numbers on the boxes or bags. A few...
-
Max the Mac Man replied to the thread MCCULLOCH The official McCulloch thread.Went to Savannah to celebrate our anniversary, was representing at dinner...
-
-
Max the Mac Man replied to the thread MCCULLOCH The official McCulloch thread.Alan and myself are in the middle of a little project...
-
-
Max the Mac Man reacted to cinci5's post in the thread MCCULLOCH The official McCulloch thread with Like.
Just been going thru old archives in family business and found these. McCulloch has been in my family since since 1949 but this was the...
-
Max the Mac Man reacted to Woodslasher's post in the thread MCCULLOCH The official McCulloch thread with
Haha.
True, but in the other shop bay there are a few nut and bolt bins I could check first: -
Max the Mac Man reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with Like.
The spline socket is 85584, there is also a "L" shaped wrench PN 85583. Vintage Vixen was selling the "L" wrenches again recently...
-
Max the Mac Man reacted to Woodslasher's post in the thread MCCULLOCH The official McCulloch thread with Like.
Only 3 years after I got it, I finally got the clutch lapped to the crank and put my CP125 in some wood. It still needs to be tuned just...
-
Max the Mac Man reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with Like.
Polish it with some Scotchbrite and go cut wood. Mark
-
Max the Mac Man reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with Like.
These came across my bench today, not mine and will not be, but nice to look at anyway. MAC6 started life at 2.125" bore, now at...
-
Max the Mac Man replied to the thread MCCULLOCH The official McCulloch thread.If you swap the rods by removing the rod bolts and swapping them from the old crank to the newer one keep in mind two things. A) the...
-
Max the Mac Man reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with Like.
Ed - your PM55 has points ignition, make sure any crankshaft you get has the points cam/lobe. All of the 54, 57, 60, and 71cc 10 Series...
-
Max the Mac Man reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with Like.
Scott, I would normally start with 1-1/14 turns open on both H &L. The fact that it starts with throttle and no choke would indicate...
