Recent content by Marshall Rugg

I guess just not sure

Not sure what was wrong. I took carb line off gas shot out. I put carb back on. Took front muffler cover off and turned the motor over until I could see top of piston then blowed out the cylinder with air compressor. Put everything back together and took spark plug out and blower out the spark...

I did get the 044 running. What is everyone's thoughts on adjusting the carb screws. Is it easy to do without messing it up or should I take it to a shop and let them do it? I see 3 screws 2 on top and 1 below them.

I believe that's what it was. I pulled carb off to look at the diaphragm and when I pulled the gas line off gas shot out. Where is the vent located?

I just tried to start my 044. It fired one time on the second pull and shut off. I just changed the spark plug and air filter today. It has spark. The fuel lines are in good shape. It sat all summer long. I even put new gas in it. What am I missing?

I'm looking for a workshop manual for a MS 660 saw.