Maintenance Chief's latest activity
-
Lake George area -
Have a sweet spot for these. Where are you located in NY?
-
Maintenance Chief reacted to Clarkbug's post in the thread POULAN The Official Poulan Thread with
Like.
Well, I managed to find enough time to get the PP295 put back together. Carb needed a cleaning (sawdust in the screen), a kit for stiff... -
The 41 has an impulse fitting on the carb mounting block to engine that‘s prone to failing.
-
Giver a vac check 👍🏻
-
-
Maintenance Chief reacted to the 28inch mac man's post in the thread SOLD Rebuilt and ported Mcculloch pro mac 55 with Like.
This is a very nice vintage mcculloch pro mac 55 chainsaw. I went through this saw to cut firewood with it. The saw has been completely...
-
Thanks Nic, but I’ll be starting a new logging site later this week 🤞🏻
-
Maintenance Chief reacted to Creaky limb tree care's post in the thread Calling Out The Internet BS with Like.
Me too! Can anyone explain how does a crankshaft get to a temperature of between 5 or 600° Fahrenheit (temp required for bluing) without...
-
Well I am running a few saws with f##%&ed cranks then. Bluing on the crank but not on bearings or pin. Still running after about 5 years...
-
Willing to ship? I'm at 95648 thanks
-
Maintenance Chief reacted to singinwoodwackr's post in the thread Husqvarna 3-Series lot build with Like.
Ah, hadn't tried that...have glass bead booth 😃
-
Glass bead blaster takes carbon out of a chamber really well.
-
Maintenance Chief reacted to Reloaderguy's post in the thread Husqvarna 3-Series lot build with Like.
The concentrate is mixed to 10% to 20% in solution with water. It's good for more than one use. I used a gallon of mix to clean a dozen...
-
Maintenance Chief reacted to Reloaderguy's post in the thread Husqvarna 3-Series lot build with Like.
Wear Butyl gloves (not nitrile).