Maintenance Chief's latest activity
-
Maintenance Chief reacted to woodfarmer's post in the thread The forestry and logging pictures thread with
Wow.
So this big beech was leaning a few different directions, concerned about the widow maker. I chose a direction and was a bit off. Made... -
The 090g ran a 72 &96 inch bars with .404. The others, a 60 inch, some of those ran 1/2 inch chipper and chisel.
-
I sent a PM
-
I am not able to effectively use those 30 lbs saws much anymore, so am selling them off. Already sold my 090g & 3100. Now I have a 900g...
-
I have a Materminded newer style AV if interested PM me.
-
Maintenance Chief replied to the thread SELLING Stihl MS441C Magnum.I pm'ed you a ?
-
-
I do have a brass hammer
-
Also there is no play up and down with a connecting rod the normal side to side is fine I found a 500i carcass that had been run over...
-
It pulled together just fine but turning it over by hand it would not turn free and I have not yet put the seals I knew something wasn't...
-
I straightened a 7900 one after pressing in a new bearing and then welded the pin as well. Actually done it 3 times now none have...
-
Two V blocks and a dial indicator will show you the truth. I had to check a solo 681 crank after I welded the pin.
-
Actually, its been the hundred thousand 572's that have lost crank bearings that haunt me the most 🤣🤣😂
-
He probably just got done with 35 562’s though, so🤷🏽♂️😂
-
SawAgain sells them for $358.
