Maintenance Chief's latest activity
-
Maintenance Chief reacted to Stump Shot's post in the thread The Cut Report - After the Bench with
Like.
Must have been arts and crafts day when the muffler mod was done. 🙂 -
Maintenance Chief reacted to Stump Shot's post in the thread The Cut Report - After the Bench with Like.
This MS400C is cutting very well after a woods port job given to it. Very good running and cutting saw. I sure hope the new version can...
-
Maintenance Chief reacted to Czed's post in the thread Funny pic's and gifs 2021/2022/2023/2024/2025/2026 with Like.
-
We topped these two cedars today. Pretty standard job for us. Before After Cedar tapers off fast. There was only 20 foot of...
-
My new girlfriend, she’s very schlelt
-
Nice, it looks really good!!
-
I just used the light blue metallic, it’s a little bit bright and bold but it’s quite a beautiful colour
-
Just finished paint on the XL-700, next is the water slides, I bought stickers as well in case I screw up the slides. Thank god for...
-
372xp build for a friend...ground-up. Runs and cuts great. Blue, limited coil, tachs to 13+. But...comp is only 155. This was an...
-
The flat top is alive :D Runs and cuts like my old one...same motor but a RE... Scary fast with a 28, 8t, full comp. Oe topend, New...
-
Very excited about this. Just waiting on bearings to arrive.
-
I have an old ONKYO receiver that could probably stand the same treatment. Still sounds good though coupled with some Yamaha speakers. :)
-
Waiting for parts. So today I decided to clean and lube pots and switches on this old girl. Hasn't been cleaned since new in 1978. For...
-
The 33 LeSabre and Thrifty Mac were apparently put together hurriedly to provide a direct drive saw for the pulp wood cutters in Quebec...
-