Maintenance Chief's latest activity
-
This is from an operator’s manual for Husqvarna 61/268/272XP saws dated 3/1996. -
Maintenance Chief replied to the thread So what did you do today?.I'll buy those stamps for family Xmas cards right now!!! 😆
-
I’ve been burning trash since the beginning of October. There’s ton of old magazines and books but I never dug through anything other...
-
Maintenance Chief reacted to Czed's post in the thread Funny pic's and gifs 2021/2022/2023/2024/2025 with
Like.
-
I made my own too, just a couple dozen or so though. 12 & 14mm
-
Maintenance Chief reacted to jacktheripper's post in the thread Builder’s favorite build? with Like.
Don’t forget Toyota! How about the 2UZ-FE or the 5VZ-FE? I would put the 2UZ in the category of one of the most overbuilt engines of all...
-
Yeah I know all about the reliability. I’m sitting in my 2012 Camry right now.
-
Favorite saws to port: 2511t, 4910, 346NE, 400, 461, 462, 371, 500, 390, 661, 395, 2100, 3120. I might have forgotten a few.
-
Consider yourself lucky. Lol
-
Echo left a lot on the table with pretty much every motor they ever made - even the ones for Asia only. It's the Japanese way. That's...
-
I’ve never worked on a 441, but if they are an overgrown ms362, then I could see them getting big gains over stock.
-
yeah
-
That piston took a s*it before the Dominator right?
-
Maintenance Chief replied to the thread Builder’s favorite build?.I'm gonna drop a hot one here! The MS441C or regular carburetor. I think a saw of that build complexity SHOULD have left the factory...
-
While not one of my favorite saws to port, the Stihl ms362 can gain a ton. I was able to pick up 43% on power (6.6hp dyno tested) with...
