Recent content by LS50713

I got a Bunch of 394 & 395's from my faller buddy who is slowing down after 50 years of Cutting, I put together one nice 395 and rehabed 2 more for him that he uses daily, I had one 394 that put in a corner that I just kinda glanced at. Yesterday morning I decided to give it the once over. I...

Yep after diligent searching and cross referencing this is the route I am gonna go. Thanks for the info.... Plastic is not an option anymore, I hate leaks.

I am in search of a couple of these elbows to replace ones that are cracked and suck air I am not opposed to trying to rplace them with brass elbows if that is an option. Poor design is an understatement.

All coming out of the same Nozzle!

I have a fly wheel for you, 372 & 390 are the same.

I am loving the ground down Dawgs, Someone must have impaled themselves prior to you getting it. Solid Saw yes they can be hard to Crank.

Here is Oregon All I have seen is the Piss color, for 92 E-Free @ near 6.00 a gallon. Thank You Tina Kotex for you gas Tax.

Side Ports are Loud, but not as Bad as direct inline with exhaust port...

Great Looking Saw, Someone will be very excited, Xmas in April!

I always used ripping chain from madsens and had good luck with it. Then wi bought a band mill.

Lucas Red & Tacky on everything except boat trailer wheel bearings has been a winner for me.

What do you have? complete would be a bonus, trying to stay away from the commie stuff unless it boils down to it.

I am looking for a Good Clutch cover and the Case Felling Dawgs for a 3120XP wouldn't mind a Black Coil either. Cash or Trade. Located in Linn County Oregon.

Thank You

I am interested in the 12" 3/8x .050 for a 017 stihl....