I have a 12' foot dump trailer with 22" walls and 6' wide = 132 CuFt,.... 1 cord = 128 CuFt.
Loosely stacked its a bit over half a cord
This is a cord of wood on my trailer. I sell a cord @$425 delivered (dump and run). If I were a patient man I could park on the side of the freeway near...
I just completed this one for my replica MS880. I didn't like how the original exhaust deflector was blowing oil and hot gasses onto the break handle, and was starting to melt it.
I know It's ugly, but this it my first try actually welding with my TiG.
There are limiter caps on the screws, but they are regular flat head screws. And the caps can be removed easily since they are fitted only 1/2 way on the screw.
Yes!
I installed the carb just as it was right out of the box and the saw fired right up, but I did have to make some adjustment to the high and low speed needles as well as the idle screw.
The low speed needle was opened about 1/2 turn from its' factory setting.
The high speed needle was...
TL;DR.....the saw runs perfectly!!
Some details,
While testing for leaks, I did find a leak at the intake boot where the clamp pinches together. Added a few twists to the clamp screw and leak is gone, test run the saw and it still will not throttle up with out flaming out (acting lean). And...
Wow, what a coincidence! last week, my 880 also developed a very similar issue "lean condition" like symptoms. So far I have striped the carb down and removed the welch plug but did not remove the bleeder jet that protrudes in to the venturi. I found quite a bit of milling swarf under the fuel...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.