Loggernate's latest activity
-
This saw lived in northern Idaho falling primarily softer wood. I ran a 28 on it today buried in sugar maple and it actually did fine... -
Must’ve been in the carbon on top of the piston. Can still see machine lines all the way around the crown after I cleaned it off with...
-
The piston wasn’t scored. It had a few slight lines in it from dirt or that carbon on the bottom of the port. The ring was still shiny...
-
There’s a difference between “need” and “plenty good enough”. I’m not advocating for running scored pistons, especially if they are...
-
We run a 28 with full comp on Bubba's 562XP regularly. Even in hardwood it pulls it just fine. But I wouldn't even consider a 32" setup...
-
Longest bar I ran on my 562s was a 28" and I was cutting primarily Lodgepole/Pondersoa Pine and Mountain Hemlock. They would strain at...
-
Notice that I said "Might at most". You were the guy who needed to make that determination.
-
Yeah probably could’ve used a piston. I ran some scotchbrite over the whole thing and slipped it into the bore. Under .003” clearance...
-
No mysteries here. The 562 is a pain in the ass to get the bevels on the port edges to lay down and create a nice clean bevel on. A...
-
It lives
-
There ya go, Nate!
-
More pics...
-
Pics
-
This is a 462 Arctic 3/4 wrap. It is new never ran. Not much more I can say. I also have a 661 non-arctic listed. I bought some saws...
-
So, it will live to cut again! Awesome!
