lehman live edge slab's latest activity
-
lehman live edge slab replied to the thread MCCULLOCH The official McCulloch thread.Been looking at recoil repair videos for the 10 series since I have another left hand start 10-10 automatic that will run I’m sure. Had... -
lehman live edge slab replied to the thread Post up your ported cylinder Artwork.Well how’s it run ?
-
lehman live edge slab replied to the thread MCCULLOCH The official McCulloch thread.Been looking at recoil repair videos for the 10 series since I have another left hand start 10-10 automatic that will run I’m sure. Had...
-
lehman live edge slab replied to the thread ECHO Echo, Echo, Echo.Is this maybe because of the non vl vs vl? Guess I’ll need to inspect the cylinder to see if I can figure out a part number to cross
-
lehman live edge slab replied to the thread MCCULLOCH The official McCulloch thread.How many cc is this project? 70? 80?
-
lehman live edge slab replied to the thread So what did you do today?.Youngest boy shot a deer yesterday for early season youth hunt, made 30 lbs smoked cheddar polish.
-
-
lehman live edge slab replied to the thread What oil is best? and what ratio?.Yeth as Sawmakazi would say😂
-
lehman live edge slab replied to the thread What oil is best? and what ratio?.Cut the strings off on a whip and hold it open then put 16” of string out and listen to the weed whip lose rpm. 2 pieces of plastic...
-
lehman live edge slab replied to the thread 400.1 first impression.I don’t anymore either
-
lehman live edge slab replied to the thread Post up your ported cylinder Artwork.Looks like you got it done with the cut off disks. Now just to see how it runs
-
lehman live edge slab replied to the thread So what did you do today?.My uncle used an old motor to make his converter for his machine shop to run his 3 phase equipment. I don’t exactly know what you need...
-
Find yourself a big 3phase motor (10hp or bigger) for cheap. The control box and wiring is pretty reasonable, but new motors more than...
-
lehman live edge slab replied to the thread 400.1 first impression.It definitely is a bunch of bs to idle the saw 3-4 heat cycles on canned gas mixed 25:1, let sit for night and next day couple more idle...
-
These guys that have all these weird break in procedures and play sprinkles with their saws for the first how ever many tanks of gas are...
-
I don't think it's really time, it's the load put on it to seat the rings.
