lehman live edge slab's latest activity
-
lehman live edge slab replied to the thread So what did you do today?.My uncle used an old motor to make his converter for his machine shop to run his 3 phase equipment. I don’t exactly know what you need... -
Find yourself a big 3phase motor (10hp or bigger) for cheap. The control box and wiring is pretty reasonable, but new motors more than...
-
lehman live edge slab replied to the thread 400.1 first impression.It definitely is a bunch of bs to idle the saw 3-4 heat cycles on canned gas mixed 25:1, let sit for night and next day couple more idle...
-
These guys that have all these weird break in procedures and play sprinkles with their saws for the first how ever many tanks of gas are...
-
I don't think it's really time, it's the load put on it to seat the rings.
-
lehman live edge slab reacted to Lions fan's post in the thread What oil is best? and what ratio? with
Like.
I had the muffler off my 462 recently to hammer out a dent. Looks just fine to me after 2 seasons of 40:1 Red Armour. My 550xp looks... -
lehman live edge slab replied to the thread 400.1 first impression.At 50 tanks pretty sure it maxed out about 35-40 tanks ago.
-
I've had chainsaws broken in by noon.
-
lehman live edge slab replied to the thread STIHL The Official Stihl Chainsaws Thread.Yes it’s idle in triangle 45-90 seconds and shut off without touching throttle. Green is proper one for the old saws with black...
-
lehman live edge slab replied to the thread STIHL The Official Stihl Chainsaws Thread.Yes the reset procedure is 30-60 seconds in triangle then hold open and let it tune up and down. Here’s the two procedures and if it...
-
-
lehman live edge slab reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with Like.
Rather than tear the engine completely down again, I swapped the flywheel and starter shaft from an 850 that allowed the cover to fit...
-
lehman live edge slab replied to the thread What oil is best? and what ratio?.Fan doesnt load the engine down enough so it doesn’t over rev and blow up? They designed this to be under this specific load and that’s...
-
lehman live edge slab replied to the thread What oil is best? and what ratio?.The old 100:1 bottle stuff said up to 50:1 on the stuff I saw. Never seen any amsoil call for 32:1
-
lehman live edge slab replied to the thread What oil is best? and what ratio?.If held wide open like it should be that’s a full load condition
-
New 400 has much more flat power curve than other two. Much better for logging. Best saw of the three for me. Ported is a torq animal...
