Kongpils's latest activity
-
KKongpils replied to the thread Husqvarna 564xp porting.Haha sawzall cures many problems...
-
KI think my 564 order was the first one ordered as soon as it could be done. Hoping that means I'll see it soon! My buddy ordered at...
-
KKongpils replied to the thread Husqvarna 564xp porting.Feels stronger than a stock one for sure. And im sure there is more left on the table to gain also. Once the many brilliant chainsaw...
-
KKongpils replied to the thread Husqvarna 564xp porting.Adjusted the squish a little👍
-
KSome cylinders will flake no matter how careful you are and some you couldn't get to flake if you tried. Later model Huskies are...
-
KKongpils replied to the thread Husqvarna 564xp porting.Removed base gasket. And opened up the original outlet in the muffler.
-
KKongpils replied to the thread Husqvarna 564xp porting.Hey, first impression is good. Easy to work on fired up after 4 pulls in -10celsius. Feel like Husqvarna is at least trying to make a...
-
KAwesome post !
-
KKongpils replied to the thread Husqvarna 564xp porting.I have seen sugi too. But maybe because og availability? I hav run it for half a tank after porting and i think its ok for a 60cc saw...
-
KKongpils replied to the thread Husqvarna 564xp porting.Looks like a tsumura bar under the Husqvarna paint.
-
-
KKongpils replied to the thread Husqvarna 564xp porting.Very easy to work on, coil etc sits to the right side of saw next to intake. Looks like Huaqvarna tries to make a better produkt here...
-
-
KKongpils replied to the thread Husqvarna 564xp porting.Your welcome. Dont know if this saw is available in US yet. Im from Norway.
-
KKongpils replied to the thread Husqvarna 564xp porting.Plan is to delete base gasket, port to Ex:100 Tr:115 In:78. If it runs bad i can lover the jug and put som epoxy in intake. Some rough...
-
