Kdrweld's latest activity
-
KToday I installed my last two parts for a Husky 365 that I bought from @redneckhillbilly (great guy to buy from!!). This was a fun...
-
KKdrweld replied to the thread Old Homelite project 🤔.I’ve bought and used/modified a few Forrester bars because they are fairly cheap but I do love a hard tip because you can use different...
-
KFinally starting to look like a saw again 👍.
-
KIt’s actually carbon from the muffler and it bothers me greatly lol.
-
KWell, he did leave some dirt on the handle… 🤣
-
KReally clean 041 👍
-
K041av project complete. Double dogs and rim drive clutch drum.
-
KKdrweld replied to the thread Pioneer Farmsaw.Here’s where the identification tag is if that helps.
-
-
KThe model is "Farmsaw" and its displacement is 66cc. Decent saw with prestolite coil issues and a fragile starter. Make sure the auto...
-
KKdrweld replied to the thread Fixing hole in tank.I wish I had the option to use red kote, hard to find way up north
-
K$25 for 8 ounces of POR is not less expensive than $40 for a quart of Red Kote. I have used POR15 in the past and will say that in my...
-
KKdrweld reacted to hacskaroly's post in the thread MCCULLOCH The official McCulloch thread with
Like.
Here is the negative of a Husky 365/372 case gasket I cut with the Cricut: Here a test run of a carb gasket for the Prentice-Reed... -
KKdrweld reacted to hacskaroly's post in the thread MCCULLOCH The official McCulloch thread with Like.
I draw them out in Adobe Fusion and then use my wife's Cricut to cut them out. Nice crisp edges, much better than what I get trying to...
-
KKdrweld reacted to Flyinbrian's post in the thread MCCULLOCH The official McCulloch thread with Like.
Just finished the Mini Mac 6 ready to rip.
-
KKdrweld reacted to Flyinbrian's post in the thread MCCULLOCH The official McCulloch thread with Like.
Just finished the Mini Mac 35 runs perfect.
