Kdrweld's latest activity
-
KI have a nice, running, Stihl 031 AV electronic for sale. Has good compression. Idles and revs well. Very clean, with nice paint and no...
-
KThe other Jonsereds 910e is also cleaning up nicely. Replaced a rear AV bushing and rear handle assembly. This is going to get new fuel...
-
KThe 450 is starting to look a lot nicer. I have been repeatedly washing and scrubbing it to get the caked on crap off. It’s probably the...
-
KWith that you risk having something sticking out and potentially catching on something. One thing you could do is put some JB weld on...
-
KI have fixed a couple of holes in tanks using JB Weld applied from the outside only. Just make sure it's roughed up a little, is clean...
-
KI would think if pressed in fuel lines and tank vents don't leak then a tight fitting low profile rubber plug you could drill the tank...
-
KI would thread it with an 1/8 inch pipe tap then screw a brass plug in with loctite on it until it tightens up then grind the outside flat.
-
KShining a flashlight into the tank, there is luckily no corrosion inside of the tank. There is just a very minimal amount on the bottom...
-
KI am not that familiar with that saw and looking at the IPL didn't help either, I can't tell if the fuel tank/ bar oil tank come apart...
-
KKdrweld replied to the thread Fixing hole in tank.With the possible white death corrosion looking at other areas in the picture, you may have to JB weld and use a tank liner like POR-15...
-
KKdrweld replied to the thread So what did you buy today.The thoughts are on my bench. Teddy, only 3 years old before a spine thing ended him even after surgery
-
-
KKdrweld replied to the thread So what did you buy today.well, I’m sure I get to pay extra insurance next year, because my 20 year-old daughter decided to do bumper tag in the superstore...
-
KKdrweld replied to the thread MCCULLOCH The official McCulloch thread.And don’t be discouraged, trying to make gaskets just simply go buy a good punch that with different diameters and a good razor blade...
-
KKdrweld replied to the thread MCCULLOCH The official McCulloch thread.yes, just like making gaskets sometimes you just need the material to make a diaphragm. It’s simply that simple. Happy new year to...
-
KKdrweld reacted to Rallyeguy's post in the thread MCCULLOCH The official McCulloch thread with
Like.
I'm glad I was able to help with that. Just bought a bunch for inventory, so I'll be carrying it for people if they need it.
