Kdrweld's latest activity
-
KKdrweld replied to the thread What's on your bench?.The problem with Homelite gas and oil caps is they had the black gooey duck Bill come 20 years later and even 5 you’re supposed to...
-
KKdrweld replied to the thread What's on your bench?.The problem was home like gas caps, and or oil you need to take it slow because there’s always a duck Bill people go all crazy before...
-
KAn attempt to fix leaky Pioneer oil and gas caps: On the gas cap, I removed the inner plastic vent valve holder, drilled the center...
-
KPioneer/Partner p45 HP torn down for “onboarding” into my personal fleet. Doing crank seals, oiler line, oiler gasket, timing advance...
-
KThe BP-1 is getting a good clean up, I will do my best to make it operational, then fit it with an Automac bar and chain and put it in...
-
KThe sprocket nose bars were a similar design to the consumer bars of today. The sprocket teeth are quite different since the A-8 chain...
-
KA lot of people know that I collect saws, I get several calls and messages every week about wonderful opportunities to buy things. The...
-
KSome plastic repair today. One tank goes to Mr Ripper :p
-
KThe 350CS is cleaning up nicely, but the piston is done. For whatever reason, these were built with a plain bore cylinder and chrome...
-
KThis Remington SL11 was pumping a lot of air and very little oil. The pickup in the tank was pretty plugged and the line from the oil...
-
KI replaced the throttle assembly with a nos after noticing the thing was not quite getting to full throttle. Got a few hundred more rpms...
-
KFinally got this thing together.. I guess you could call it half redmax and half jonsered...going to be selling this soon..
-
KKdrweld replied to the thread What's on your bench?.If you have to put a rice rocket filter on it! 👍🏻
-
KTwo new projects… here we go!
-
KHOW DID YOU GET A BP-1?!?
