Jusgunn3's latest activity
-
JJusgunn3 reacted to Yellowking86's post in the thread HELP! 572 idles bad and won’t rev up with
Like.
I will check those thank you -
JCouple things. Check the plug and wire. Make sure the crank case bearings are good so that the flywheel can’t wobble. Check the blue and...
-
JJusgunn3 reacted to Yellowking86's post in the thread HELP! 572 idles bad and won’t rev up with Like.
I bought a 572 on marketplace and it idles if I press the throttle slightly but won’t rev up at all and seems like it floods at idle and...
-
JGot this one from Jack in a box. Flattened and resealed riser, ground out riser dividers, cleaned transfer off cylinder and put a hyway...
-
JI guess it seasoned sufficiently and I could finally use it. :rolleyes:
-
JYou say factory grind is poor???? Explain please. I just set up an old Simington 450 close to factory angles…. (Not trying to hijack...
-
JJusgunn3 replied to the thread WANTED Square Ground.I only have 3/8 .063…
-
JRegular RS and RSK have different top plate angles (from cutting edge to butt of the cutter) and also different raker profiles. Lastly...
-
JJusgunn3 replied to the thread What oil is best? and what ratio?.Looks like there are plenty to choose from
-
JDon't have an opinion on the company, but AMSOIL Saber (at 40:1) lubricates very well and burns clean. I use it in ALL my 2-cycle...
-
JFor bike bike oils- Maxima K2, Motorex Cross Power, Yamaha 2R and Honda Hp2. OPE oils- Red Armor, Redmax Maxpro/ Husky XP+. These are...
-
JI ran into some unfortunate bills and really need to move some of these saws shoot me an offer
-
JJusgunn3 replied to the thread SELLING Husqvarna 350.Sorry to hear about this, Shane. GLWS
-
JGot this 350 setup I was going to put a 346 cylinder on but haven't got around to it but it is ready for a cylinder. Sealed up riser...