Jusgunn3's latest activity
-
JMore pictures
-
JNice looking 55. Wish I had the funds.
-
JHusqvarna 55 Rancher. Runs great. Very good condition. New fuel line, filter, air filter, spark plug, carb kit, sprocket, oil cap, pull...
-
JLol, how about you pm the seller?
-
JLOL!!! Why didnt i think of that. LOL must be too many beers :)
-
JJusgunn3 replied to the thread Oregon grinder stopped working.Well gents, got the grinder apart and changed the capacitor and it fired right up. When putting it back together somehow I broke the...
-
JJusgunn3 replied to the thread SELLING McCulloch Pro Mac 850/800.I think I am going to pass on this one, I have to replace my heat pump now and that’s going to set me back for a while…🤦♂️
-
JHonestly, I know this is a royal pain in the arse, but can I pass on it now? Im sure someone else will immediately pick up it up...
-
JI wish I had a SP81. Ive tried to get one but everytime I do someone else gets to it before I Can. Do you have experience with the...
-
JAll of the 800 series i ran i didn't have a problem with any mufflers. Only thing I thought was bad was the placement. Logging walnut...
-
JI have three runners in this series. 81, 800 and 850. Of those I found the 800 to be the lowest performing. I replaced the awkward...
-
JJusgunn3 reacted to Squareground3691's post in the thread SELLING McCulloch Pro Mac 850/800 with
Like.
I did the same thing, made the saw performance way better, the 800 muffler was a terrible design, -
J600072 is a PM800 as noted. That muffler and the bolt suggest is has the Q port and was not intended to have a compression release...
-
JThey always said the 81 was like a ported saw anyway. Cut lots of walnut with them and the 850's. They run well the way they are. And...
