Jusgunn3's latest activity
-
J600072 is a PM800 as noted. That muffler and the bolt suggest is has the Q port and was not intended to have a compression release...
-
JThey always said the 81 was like a ported saw anyway. Cut lots of walnut with them and the 850's. They run well the way they are. And...
-
JJusgunn3 replied to the thread SELLING McCulloch Pro Mac 850.I’m sure it rips as is, not sure about the muffler swaps. Have fun with that baby!
-
JI had some questions about the model tag, decomp, and a compression reading. I took some pictures this afternoon. The decomp has been...
-
JPics
-
JRandy's Engine Repair lists 600072B as a Pro Mac 800 made 8/80-9/81, for whatever that's worth.
-
JHey eveyone its me the buyer. I got a question for yall. Im assuming its impossible to find the DSP plug for these PM800 cylinder...
-
JSummer chainsaw finished, got a few new parts….case, fuel tank, top cover, handlebar, start cover, brake flag, oil pump, clutch, boot...
-
JJusgunn3 replied to the thread Oregon grinder stopped working.I bought a capacitor on eBay, going to give it a try I guess…
-
JYou'll need to take the motor apart and then search for the right starting capacitor.
-
JJusgunn3 replied to the thread SELLING McCulloch Pro Mac 850.Man, missed this one but second if it does not sell
-
JThis is a used McCulloch Pro Mac 850. I have had this saw for quite a few years, and it has just sat on the shelf. It is in pretty clean...
-
JPics
-
JPics
-
JPM'd
