Jusgunn3's latest activity
-
JMore pictures
-
JLooks to be a new 7900. I took this in on trade. I haven't add mix to it yet. A logger bought it as a backup.. He was very interested...
-
J@Woodrow
-
J***Trade deal made with 1Snowcat*** Husqvarna 350. This saw runs great. I replaced the plastic intake clamp with a metal one. New...
-
J44.3mm>42>45>44. No experience with Duke's. Did a Hyway 45mm bottom fed quad port. That ran ok. Probably better than an OEM 45mm...
-
JId like to find a cylinder for some of these part saws I just got. What is the general consensus on best cylinders for 346xp? Would it...
-
JEcho 4910 ported and muffler mod by 307Performance Saws. It’s a screamer. I’m just downsizing the firewood business and don’t need it...
-
JI can vouch for Caleb from 307 performance saws. He’s a good buddy of mine and a stand up guy.
-
JIn this frigid sht hole, cardboard is not enough to keep the cold out of the engine bay. Back in 2017 when I was still kinda green to...
-
JI've dealt with -20 quit often here in MT. I've seen -30 a couple times, but no colder. -57 is ridiculous! I guess there is a reason...
-
JCosmetically rough Boost port P52. Saw has been split, new bearings, new OEM piston, lines, gaskets, filters, etc. The cylinder was in...
-
JOils like a hog, by the way.
-
J@jacktheripper
-
JOoooooo
-
JDon't know if this is clear enough to see but it is a Winchester axe. I am not crazy for axes but still hope some collector will give me...
