Jusgunn3's latest activity
-
JThis is my personal saw. Should be ready to work. It has the Eagan muffler cover, but can include the original cover. Started out with...
-
JJusgunn3 reacted to Maintenance Chief's post in the thread Husqvarna 564xp (g) fuel inject with
Like.
This must be why the guys I cut with and myself don't have the bearing problems. We are chain sharpening fools!, but honestly once you... -
JI have seen it on a Husqvarna concrete saw too, probably a K760 although that was years ago. Otherwise yes, only 372 XT. Seeing it only...
-
JBearings on the saw spin around and around... 🎶
-
JQuote from your source- "Crankshaft flexing is what wears out the bearing pockets. The majority of the flex occurs in the crank pin...
-
JVery interesting read, thanks for linking that. Echo uses steel pocket liners in their CS-620/600/590 model saws. I always figured that...
-
JIsn’t it ‘round and ‘round? 😋
-
JWow, I never knew about these steel pocket liners on the 620/590. With that freakishly long stroke, always wondered why the dmn things...
-
JJusgunn3 reacted to Maintenance Chief's post in the thread Husqvarna 564xp (g) fuel inject with Like.
I know the early 044 had a steel insert in the pto side too.
-
JThere's been a lot of buzz going around about interest in the new 564XP saw with folks I talk to. Personally, I am excited to get inside...
-
JNicely and well put! Actual real life testimony based on facts and not just hear say!
-
JNew 395 cylinder without piston. 150 shipped Paypal Thank you
-
JTo the top.
-
Jto the top
-
JPopped in bacon grease.