Jusgunn3's latest activity
-
JThere are many different ways to do a muffler mod on these and results may vary depending on what other modifications you do along with...
-
JIf you are just interested in getting a 350 back up and running well in a stock configuration, addressing the three issues above should...
-
JThe last big problem area for these saws is the mufflers rattling themselves loose. On some saws this led to exhaust gases burning a...
-
JThere is definitely value in taking some time to modify the stock 350 for a low-buck rig. If you have run a good ported 346xp, you can...
-
Jmessage sent
-
JThanks David!
-
JI always get concerned when I see a first time post from someone under a want add..
-
JWeekend special $350.00 plus shipping cost ttt
-
JAround seven years ago I did a 350 build with no timing changes. I got rid of restriction in the cylinder riser, smoothed all of the...
-
JThe next problem spot I want to address (only applies to saws with the cylinder riser) is the cylinder riser. On every single 350 I...
-
JThe first problem area on these saws that I want to cover is the intake boot clamp. Husky for some reason decided to use an integral...
-
JAlright gang, sounds like there is enough interest in a thread on building husky 350's and their related plastic-cased variants (Husky...
-
JJusgunn3 replied to the thread Oil questions....Just run Dominator or red armor and call it a day…
-
JI have never had a piece of equipment that burned dirty or made carbon... because I use quality oil of the right type and I can tune a...
-
JAlmost the only times I see fouled plugs are from dirt or on a small 4-stroke Honda or similar that is overfilled with oil. The pictures...
