Jusgunn3's latest activity
-
JThe 550 & 562xp’s do most of the fire wood bucking, unless it’s a monster log. Felling is usually the 565 that’s now quite a zippy...
-
JThe frown is for the scum, in general…
-
JHey! @singinwoodwackr ! Turn that frown upside down! We smack down the scumbags to protect buyers, but also to make a better place for...
-
JAll saws are firewood saws! No, that another one. We had three in like two days.
-
JOne of these days I’ll tear mine down and figure out what’s wrong :p
-
JDon’t worry, I’ll take it for you!
-
JI want to use my 266xp again, so it’s time to tear this thing down and do the bearings
-
JWell it has become very obvious to me that I somehow sabotaged my own saw. As soon as I started tearing it down, I removed the air...
-
JI may have done similar to my 2100.
-
JPiston and cylinder were fine. Crank was fine. I got lucky. Cases cleaned up, old bearings removed. Ready for reassembly tomorrow with...
-
JJusgunn3 reacted to EFSM's post in the thread Any Chinese chainsaw and chinese parts discussion with
Like.
Not sure if your 372 is xtorq or not but the OE was way easier on bottom ends. -
JJusgunn3 reacted to Maintenance Chief's post in the thread Any Chinese chainsaw and chinese parts discussion with Like.
No doubt the stigma around clones in" my experience" is over stated . I also think some people shouldn't be allowed to have children! Lolol
-
JJusgunn3 reacted to Outback's post in the thread Any Chinese chainsaw and chinese parts discussion with Like.
There's something to be said for proper oil. The Chinese did not expect or recommend that anybody run 50/1.
-
JJusgunn3 reacted to farminkarman's post in the thread Any Chinese chainsaw and chinese parts discussion with Like.
I built a 372 from a “kit” three years ago. That saw was entirely AM, and I cut 0.050” from the squish band on it and ported it. That...
-
JJusgunn3 reacted to hacskaroly's post in the thread 2025 Christmas Giveaway Saw MS390 - Boedy @ Empire Builders (Closed) with Like.
Awesome, thanks!!