Jusgunn3's latest activity
-
JWhat's 114 put blowdown at?
-
JIf I had a lathe, I'll keep it on the shelf with that in mind.
-
J12 degrees.
-
JYou considered raising the exhaust roof 4 degrees? Torque may be peaky but it'd be fast. 16 blowdown is a bit small and 98 exhaust a...
-
JThis is a project I picked up back in the summer and im just not going to get to it anytime soon so id like to free up some space and...
-
JMore pics ...
-
JIt looks like I have my first ruined cyl. under my belt, apparently the degree wheel must have moved. Today I ground the transfers to...
-
JSelling my ms500i in like new condition. Took this on trade several months back for my MMWS 400. I’ve put a couple tanks thru it. Runs...
-
JSold
-
JOh yeah...I have repunched my fair share of links :D
-
JOr, go too far and seize the links 😒 Then, start over…
-
JI can vouch for this, the most problems I have had were with the 3/8 picco / low profile, I have to take more time with it than with 3/8...
-
JThe shape of the spinner anvil can be a factor. On A.S. some guys commented on problems spinning 3/8 low profile (‘Picco’) presets...
-
JGood info guys. @hacskaroly Aside from wanting them to look factory, drag is my main concern (albeit maybe moot). Unless completely...
-
JRegarding the first question. unless the number of drive links is divisible by 4, you will end up with either a blank space (odd DL...
