Jusgunn3's latest activity
-
JLast old saw I bought came with a couple of chains. At a glance they looked like they had a lot of meat left on them. Turns out they...
-
JNo kidding!
-
JYeah it's down right painful, some of the chains I get a stupid dull beyond belief.
-
JI hear neighbors around me now and then, and you can hear their saws just screaming in the cut from dull chains. Makes me cringe.
-
JBefore parts became unavailable for the 346 chassis, I built quite a few hybrids on 345's & 350's with OEM 44.3mm top ends. If parts...
-
JCutting base drops intake to the high 70s and exhaust to low 100s where many saws run the best at. Gotta cut it a lot though. What it...
-
JIf everybody mastered carb tuning and chain sharpening, the parts and repair industries would be in serious trouble.
-
JThe average guy cant tune a carb to save his life.
-
JHonestly not enough for the time and money you spend. Messing around with a 260 is throwing good money at bad.
-
JAnd the other kind... On another forum, a guy was having trouble with a new saw. When i mentioned adjusting the carb, he threw a...
-
JI see both sides also but I’m after dead nutz reliability.
-
J261’s old will be an all new saw coming soon. Scott likes the mtronic himself better also from a performance standpoint anyway. From...
-
JUntil I’m forced into mtron/fi, only screw saws here. I figure when the 261 gen 3 comes out, won’t be able to get a standard carb.
-
JGreat saw except I’d want one without screws personally
-
JGo ahead and shut this one down, I present peak 50cc greatness.
